Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Tukwila?
Garage door repair in Tukwila typically costs $150-$600, depending on what failed and how many parts are involved. A single broken spring runs $180-$340, while a full new door installation runs $700-$2200. Those are estimated ranges for the Tukwila market in 2026 – the written estimate we give you after looking at the door sets the final price.
We’re Kent Garage Door Repair Co, and we handle the full job: springs, cables, openers, panels, tracks, and new doors. Our technicians have up to 15 years of experience, and we’re certified to service eight of the most widely installed brands – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That means whoever comes out already knows the hardware bolted to your ceiling. Call (866) 937-7308 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm Sunday through Friday.
Key Takeaways
- Most Tukwila garage door repairs land between $150 and $600.
- A single spring replacement is $180-$340; a matched pair is usually replaced together and costs about twice that.
- Opener repairs run $120-$320; a new opener installed runs $250-$550.
- New door installation is $700-$2200, and the door’s size, material, and insulation drive most of that.
- Estimates are free, and the written estimate is the price.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs cost in Tukwila this year. Every figure is a typical estimated range for the work, not a quote for your specific door.
| Service | Typical Estimated Range |
|---|---|
| Garage door repair (general) | $150-$600 |
| Spring repair (one spring) | $180-$340 |
| Cable repair | $130-$250 |
| Opener repair | $120-$320 |
| Opener installation | $250-$550 |
| Panel replacement | $250-$500 |
| Track realignment | $120-$240 |
| Roller replacement | $110-$220 |
| New door installation | $700-$2200 |
One thing worth calling out plainly: the spring range is for one spring. Garage doors almost always use two springs, and when one breaks the other is carrying the same load and the same wear, so a matched pair is usually replaced together. A pair costs about twice the single-spring range. We’ll tell you which situation you’re in before any work starts.
What pushes a job toward the top of a range? Extra parts, a heavier door, a torsion system instead of extension springs, or a door that’s been out of alignment long enough that several components wore together. What keeps it near the bottom? A single straightforward failure – one cable, one set of rollers, one opener logic board – on a door that’s otherwise sound. Our approach is repair first. If the door can be fixed safely and correctly, we fix it. Replacement only comes up when the door’s structure or the cost math genuinely points that way.
What Affects Garage Door Pricing in Tukwila
- Door type and spring system. Torsion springs, mounted on a shaft above the door, take more setup and a different set of tools than extension springs. Most newer Tukwila homes have torsion systems, and that shapes the labor on a spring job.
- Door size and weight. A single-car door is lighter and faster to work on than a double-car door. Heavier doors need heavier springs, stiffer tracks, and more careful balancing, and all of that shows up in the estimate.
- Brand and parts availability. We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. If your door or opener is one of those, the parts side of the job is predictable. If it’s an older or unusual unit outside that list, the estimate takes more digging.
- How many parts failed at once. A snapped cable often takes a roller or a track section with it. The more components on the same job, the higher the total, but the per-part cost usually comes down compared with fixing them one at a time.
- Age and condition of the door. A door with rusted hinges, a bent bottom section, or a sagging top panel needs more than the obvious repair. We check the whole assembly so the fix holds.
- New door specs. On installation, the range widens with material (steel, aluminum, wood), insulation, window inserts, and whether the opening needs any framing adjustment. A basic single steel door sits near $700; a large insulated double door with windows heads toward $2200.
Tukwila’s weather matters here too. The long wet stretch from fall into spring works on steel and hardware, and doors that sit in persistent damp tend to show rusted hinges, stiff rollers, and swollen wooden sections sooner than doors in drier climates. It’s one reason we look at the whole door and not just the part that made the noise.
Can You Fix It the Same Day?
Often, yes. Spring, cable, roller, and opener failures are usually repairable in a single visit when the parts are standard for the brand, which is most of the time on the eight brands we service. Call (866) 937-7308 early and there’s a good chance the door is back up and running before the day is out. We answer 24/7, and dispatch runs 7am to 7pm Sunday through Friday.
If your door is stuck open, off its tracks, or hanging unevenly, that’s an emergency garage door service situation – the home isn’t secured or the car is trapped. Say so when you call and we’ll treat it that way. A call outside dispatch hours gets booked into the next opening.
One safety note that’s worth being direct about: springs and cables are under extreme tension, and a spring repair is a two-person job with proper winding bars and the door clamped in place. This isn’t a task to attempt with a ladder and a YouTube video. The stored energy in a torsion spring can cause serious injury when it releases unexpectedly. Our technicians handle it with the right tools and the right procedure, every time.
How to Save on Garage Door Costs in Tukwila
- Get the estimate before the work. Every estimate from us is free, and the written estimate is the price – no surprises added afterward. Call (866) 937-7308 to set one up.
- Fix the small stuff early. A squeaking roller or a slightly misaligned track is a $110-$240 job. Left alone, it wears the door and turns into panel or spring work at several times that.
- Replace springs as a pair. It feels cheaper to swap one spring, but the second one is on the same clock and usually fails soon after. Doing both at once saves the second visit.
- Repair the opener before replacing it. Plenty of “dead” openers are a logic board, a gear, or a sensor alignment away from working fine. Opener repair runs $120-$320 against $250-$550 for a new unit, so it’s worth diagnosing first.
- Ask about the brand you already own. Because we’re certified on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, we work on the door and opener you already have instead of steering you toward a full replacement.
- Don’t wait on a bent track. A door running on a misaligned track grinds its rollers and strains the opener. Realigning the track early ($120-$240) is far cheaper than the chain of repairs a leaning door causes.
Repair or Replace? How the Numbers Usually Fall
For most Tukwila homeowners the answer is repair. A door in decent structural shape with a failed spring, cable, or opener is a $120-$340 fix, and there’s no reason to spend $700-$2200 replacing a door that’s otherwise sound. Replacement starts to make sense when the door has multiple bent panels, a cracked or rusted-through bottom section, or a repair quote that climbs toward the low end of the installation range. Even then, a single panel replacement at $250-$500 often buys years more service. We’ll lay out both paths with numbers and let you decide.
Why Brand Compatibility Keeps the Cost Predictable
A big hidden variable in garage door pricing is whether the technician knows your hardware. We’re certified to service eight of the most widely installed brands – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor – so the diagnosis is faster and the parts are the right ones for the door. That matters most on modern openers, where smart-home features, battery backup, and Wi-Fi control add complexity that generic repairs can miss. We handle opener repair across both older units and current smart-home-integrated systems, which usually means keeping the opener you have rather than selling you a new one. If you’re researching a full replacement, see our garage door installation page for how the process runs.
What a Typical Tukwila Garage Door Visit Involves
When we come out, we start by looking at the whole door, not just the part you called about. That means checking the springs and cables for wear and tension, running the door by hand to feel for balance issues, testing the opener and its safety sensors, and inspecting the tracks, rollers, and hinges. You get a written estimate with the line items and a clear recommendation – repair where repair is the right call, replacement if it genuinely isn’t. If the door is unsafe to operate, we say so and secure it before we leave. Most standard repairs are finished on the same visit.
FAQs – Garage Door Cost
How much does garage door repair cost in Tukwila?
Garage door repair in Tukwila typically runs $150-$600, depending on the failure. A single spring is $180-$340, a cable is $130-$250, and an opener repair is $120-$320. Call (866) 937-7308 for an exact quote – estimates are free.
How much does a new garage door cost in Tukwila?
A new garage door installed in Tukwila typically costs $700-$2200. A basic single steel door sits near the low end; a large insulated double door with windows heads toward the top. Call (866) 937-7308 for a free estimate on your specific opening.
Is it cheaper to repair or replace a garage door?
Repair is almost always cheaper. A typical single repair is $120-$340 against $700-$2200 for a new door, so replacement only wins when the door has several failed sections or a repair bill climbing toward installation pricing. Call (866) 937-7308 and we’ll give you both numbers.
How much does garage door spring repair cost in Tukwila?
Spring repair in Tukwila is $180-$340 for one spring, and a matched pair costs about twice that because both springs wear together and are usually replaced as a set. Call (866) 937-7308 for a free estimate – and please don’t attempt this one yourself, since the springs hold serious stored tension.
Can you come today?
Usually, yes. Spring, cable, roller, and opener repairs are typically done in a single same-day visit when the parts are standard for the brand. Call (866) 937-7308. We answer 24/7, with fast dispatch from 7am to 7pm Sunday through Friday.
Whether your door just snapped a spring, the opener quit, or you’re weighing a new install, the fastest way to a real number is a quick call. Call (866) 937-7308 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm Sunday through Friday. We’ll tell you what’s wrong, what it costs, and whether repair or replacement makes more sense – and you’ll get a straight answer either way. You can also start at Kent Garage Door Repair Co.
Pricing reflects the Tukwila market as of 2026. Kent Garage Door Repair Co offers free estimates – call (866) 937-7308.
What Our Customers Say
"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Nathan Hayes"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Neil Rao"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Alma Mendoza